Step 3, Photo 6
Seal up the exposed coax braid with liquid tape or silicone sealant to keep moisture out. Apply it also to the
metal of the terminals as the metal is steel and will rust if not protected. Paint has been applied.
The driver wires will be bent to an "L" shape on the ends and pushed down into the tops of the terminals. Add
a 1/2 inch to each driver half wire in Step 4.
The feed line will also be connect to the top terminal and looped down the side of the post to the bottom of the
hex beam.
metal of the terminals as the metal is steel and will rust if not protected. Paint has been applied.
The driver wires will be bent to an "L" shape on the ends and pushed down into the tops of the terminals. Add
a 1/2 inch to each driver half wire in Step 4.
The feed line will also be connect to the top terminal and looped down the side of the post to the bottom of the
hex beam.
Hexagonal beam by K4KIO