Use the table on the Specifications page for the lengths to measure and cut as shown above.
You will need one set of the elements above for each band on your hexbeam.
The cords can be made of Kevlar which has very little stretch or Dacron.
When finished, connect all the pieces together for a complete wire assembly.
You will need one set of the elements above for each band on your hexbeam.
The cords can be made of Kevlar which has very little stretch or Dacron.
When finished, connect all the pieces together for a complete wire assembly.
Step 4 photo 2
Hex beam by K4KIO
| 1/2 Driver wire. Include the lug and allow about 1/2 inch on the other end to fit into the Euro terminal |
| Reflector wire. Include the lugs in your measurements |
| Two cords and allow an inch on each end to tie knots to the reflector lugs. |