Connect each of the tip spacers to the ends of the driver wire and reflector wire. Then adjust
the tip spacers for 24 inches for 20 meters and tighten the set screws.
Assemble the wires and tip spacers for the other bands using the lengths on the
Specifications page. No terminal strips other than those used on the tip spacers should be
used. The other bands' wire/tip spacer assemblies will be attached to spreaders using cable
ties.
the tip spacers for 24 inches for 20 meters and tighten the set screws.
Assemble the wires and tip spacers for the other bands using the lengths on the
Specifications page. No terminal strips other than those used on the tip spacers should be
used. The other bands' wire/tip spacer assemblies will be attached to spreaders using cable
ties.
Step 6 photo 6
Hex beam by K4KIO
