Using the Kevlar cord and crimps, make a pair of these for each band using the lengths in the
previous photo. Lengths are between the metal lugs on the ends. Slip two 2 inch lengths of
heat shrink over each Tip Spacer for use after the wires are soldered. Carefully label each
pair so as not to get them mixed up.
The lugs will be soldered to the wires in the next step to complete the wire set.
previous photo. Lengths are between the metal lugs on the ends. Slip two 2 inch lengths of
heat shrink over each Tip Spacer for use after the wires are soldered. Carefully label each
pair so as not to get them mixed up.
The lugs will be soldered to the wires in the next step to complete the wire set.
Step 4 photo 3
Hexagonal beam by K4KIO