Step 4 photo 4
Hexagonal beam by K4KIO
Solder a lug to one end of each 1/2 driver
wire. Solder the other end of each 1/2
driver wire to one end of each Tip Spacer.
Then solder the other end of each Tip
spacer to the ends of the Reflector wire.
When the joints cool, slip the heat shrink
over the crimps and with a hair dryer,
match or other heat source, shrink the
shrink.
Repeat for each band, being careful to
label each one. You will have five wire sets
like this.
wire. Solder the other end of each 1/2
driver wire to one end of each Tip Spacer.
Then solder the other end of each Tip
spacer to the ends of the Reflector wire.
When the joints cool, slip the heat shrink
over the crimps and with a hair dryer,
match or other heat source, shrink the
shrink.
Repeat for each band, being careful to
label each one. You will have five wire sets
like this.