Install the coax pieces between the terminals. Also install the coax piece from the top as
shown here down the side of the post and through the hole in the base plate. This photo
was taken after the driver wires and radial cords were installed.
Use stainless hardware. Lock washers will help keep the connections tight as the wind seeks
to loosen everything. I even put a bit of super glue on the end of the screw.
Bring the coax down the side of the post, not between the driver wires as this will mess up
the performance.
shown here down the side of the post and through the hole in the base plate. This photo
was taken after the driver wires and radial cords were installed.
Use stainless hardware. Lock washers will help keep the connections tight as the wind seeks
to loosen everything. I even put a bit of super glue on the end of the screw.
Bring the coax down the side of the post, not between the driver wires as this will mess up
the performance.
Step 5 photo 5
Hex beam by K4KIO
