The vertical lines to mark the terminal bolts should be 60 degrees apart. The 60 degrees
can be marked from the lines on the base plate by sticking the center post down into the
base plate before the flange is attached.
The post should be about 46-48 inches above the baseplate with about 6-8 inches below.
can be marked from the lines on the base plate by sticking the center post down into the
base plate before the flange is attached.
The post should be about 46-48 inches above the baseplate with about 6-8 inches below.
Step1 photo 9
Hex beam by K4KIO